| # Configuration options for the Zephyr serial 1-Wire Master driver |
| |
| # Copyright (c) 2022 Thomas Stranger |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| config W1_ZEPHYR_SERIAL |
| bool "1-wire Serial" |
| select SERIAL |
| default y |
| depends on DT_HAS_ZEPHYR_W1_SERIAL_ENABLED |
| select UART_USE_RUNTIME_CONFIGURE |
| help |
| This option enables the Zephyr serial 1-Wire master driver. |
| |
| The bus reset, and bit read and write operations are executed |
| via bytes read and write operations on top of the Zephyr |
| serial driver interface. |
| |
| if W1_ZEPHYR_SERIAL |
| |
| config W1_ZEPHYR_SERIAL_BIT_TIMEOUT |
| int "Bit read timeout in us" |
| default 380 |
| help |
| The bit read timeout specifies how long the driver tries to read the |
| uart byte (1-wire standard speed data bit). |
| For serial drivers where poll_out does not block until the transfer is |
| complete, it must at least be greater than 87us (10bits / 115.2 kBd). |
| |
| endif # W1_ZEPHYR_SERIAL |
