blob: e7dbfe9b540a24d10ed22d8a51b20516550018a5 [file] [log] [blame]
# nRF9160 DK NRF9160 board configuration
# Copyright (c) 2018-2020 Nordic Semiconductor ASA
# SPDX-License-Identifier: Apache-2.0
if BOARD_NRF9160DK_NRF9160 || BOARD_NRF9160DK_NRF9160_NS
config BOARD
default "nrf9160dk_nrf9160"
# By default, if we build for a Non-Secure version of the board,
# force building with TF-M as the Secure Execution Environment.
config BUILD_WITH_TFM
default y if BOARD_NRF9160DK_NRF9160_NS
depends on ZEPHYR_TRUSTED_FIRMWARE_M_MODULE
if BUILD_WITH_TFM
# By default, if we build with TF-M, instruct build system to
# flash the combined TF-M (Secure) & Zephyr (Non Secure) image
# (when building in-tree tests).
config TFM_FLASH_MERGED_BINARY
bool
default y if TEST_ARM_CORTEX_M
endif # BUILD_WITH_TFM
# For the secure version of the board the firmware is linked at the beginning
# of the flash, or into the code-partition defined in DT if it is intended to
# be loaded by MCUboot. If the secure firmware is to be combined with a non-
# secure image (TRUSTED_EXECUTION_SECURE=y), the secure FW image shall always
# be restricted to the size of its code partition.
# For the non-secure version of the board, the firmware
# must be linked into the code-partition (non-secure) defined in DT, regardless.
# Apply this configuration below by setting the Kconfig symbols used by
# the linker according to the information extracted from DT partitions.
# Workaround for not being able to have commas in macro arguments
DT_CHOSEN_Z_CODE_PARTITION := zephyr,code-partition
config FLASH_LOAD_SIZE
default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION))
depends on BOARD_NRF9160DK_NRF9160 && TRUSTED_EXECUTION_SECURE
if BOARD_NRF9160DK_NRF9160_NS
config FLASH_LOAD_OFFSET
default $(dt_chosen_reg_addr_hex,$(DT_CHOSEN_Z_CODE_PARTITION))
config FLASH_LOAD_SIZE
default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION))
endif # BOARD_NRF9160DK_NRF9160_NS
config BT_HCI_VS
default y if BT
config BT_WAIT_NOP
default BT && $(dt_nodelabel_enabled,nrf52840_reset)
# Workaround for not being able to have commas in macro arguments
DT_COMPAT_NXP_PCAL6408A := nxp,pcal6408a
config I2C
default $(dt_compat_on_bus,$(DT_COMPAT_NXP_PCAL6408A),i2c)
endif # BOARD_NRF9160DK_NRF9160 || BOARD_NRF9160DK_NRF9160_NS