blob: 65c3cdd6fda49e013e3e7e720690797152d946b1 [file] [log] [blame]
/*
* Copyright (c) 2023 Nordic Semiconductor ASA
* SPDX-License-Identifier: Apache-2.0
*/
#define DT_DRV_COMPAT nordic_npm1300_gpio
#include <errno.h>
#include <zephyr/drivers/gpio.h>
#include <zephyr/drivers/gpio/gpio_utils.h>
#include <zephyr/drivers/mfd/npm1300.h>
#include <zephyr/dt-bindings/gpio/nordic-npm1300-gpio.h>
#include <zephyr/kernel.h>
#include <zephyr/sys/util_macro.h>
/* nPM1300 GPIO base address */
#define NPM_GPIO_BASE 0x06U
/* nPM1300 GPIO registers offsets */
#define NPM_GPIO_OFFSET_MODE 0x00U
#define NPM_GPIO_OFFSET_DRIVE 0x05U
#define NPM_GPIO_OFFSET_PULLUP 0x0AU
#define NPM_GPIO_OFFSET_PULLDOWN 0x0FU
#define NPM_GPIO_OFFSET_OPENDRAIN 0x14U
#define NPM_GPIO_OFFSET_DEBOUNCE 0x19U
#define NPM_GPIO_OFFSET_STATUS 0x1EU
/* nPM1300 Channel counts */
#define NPM1300_GPIO_PINS 5U
#define NPM1300_GPIO_GPIINPUT 0
#define NPM1300_GPIO_GPILOGIC1 1
#define NPM1300_GPIO_GPILOGIC0 2
#define NPM1300_GPIO_GPIEVENTRISE 3
#define NPM1300_GPIO_GPIEVENTFALL 4
#define NPM1300_GPIO_GPOIRQ 5
#define NPM1300_GPIO_GPORESET 6
#define NPM1300_GPIO_GPOPWRLOSSWARN 7
#define NPM1300_GPIO_GPOLOGIC1 8
#define NPM1300_GPIO_GPOLOGIC0 9
struct gpio_npm1300_config {
struct gpio_driver_config common;
const struct device *mfd;
};
struct gpio_npm1300_data {
struct gpio_driver_data common;
};
static int gpio_npm1300_port_get_raw(const struct device *dev, uint32_t *value)
{
const struct gpio_npm1300_config *config = dev->config;
int ret;
uint8_t data;
ret = mfd_npm1300_reg_read(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_STATUS, &data);
if (ret < 0) {
return ret;
}
*value = data;
return 0;
}
static int gpio_npm1300_port_set_masked_raw(const struct device *dev, gpio_port_pins_t mask,
gpio_port_value_t value)
{
const struct gpio_npm1300_config *config = dev->config;
int ret = 0;
for (size_t idx = 0; idx < NPM1300_GPIO_PINS; idx++) {
if ((mask & BIT(idx)) != 0U) {
if ((value & BIT(idx)) != 0U) {
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE,
NPM_GPIO_OFFSET_MODE + idx,
NPM1300_GPIO_GPOLOGIC1);
} else {
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE,
NPM_GPIO_OFFSET_MODE + idx,
NPM1300_GPIO_GPOLOGIC0);
}
if (ret != 0U) {
return ret;
}
}
}
return ret;
}
static int gpio_npm1300_port_set_bits_raw(const struct device *dev, gpio_port_pins_t pins)
{
return gpio_npm1300_port_set_masked_raw(dev, pins, pins);
}
static int gpio_npm1300_port_clear_bits_raw(const struct device *dev, gpio_port_pins_t pins)
{
return gpio_npm1300_port_set_masked_raw(dev, pins, 0U);
}
static inline int gpio_npm1300_configure(const struct device *dev, gpio_pin_t pin,
gpio_flags_t flags)
{
const struct gpio_npm1300_config *config = dev->config;
int ret = 0;
if (k_is_in_isr()) {
return -EWOULDBLOCK;
}
if (pin >= NPM1300_GPIO_PINS) {
return -EINVAL;
}
/* Configure mode */
if ((flags & GPIO_INPUT) != 0U) {
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_MODE + pin,
NPM1300_GPIO_GPIINPUT);
} else if ((flags & NPM1300_GPIO_WDT_RESET_ON) != 0U) {
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_MODE + pin,
NPM1300_GPIO_GPORESET);
} else if ((flags & NPM1300_GPIO_PWRLOSSWARN_ON) != 0U) {
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_MODE + pin,
NPM1300_GPIO_GPOPWRLOSSWARN);
} else if ((flags & GPIO_OUTPUT_INIT_HIGH) != 0U) {
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_MODE + pin,
NPM1300_GPIO_GPOLOGIC1);
} else if ((flags & GPIO_OUTPUT) != 0U) {
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_MODE + pin,
NPM1300_GPIO_GPOLOGIC0);
}
if (ret < 0) {
return ret;
}
/* Configure open drain */
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_OPENDRAIN + pin,
!!(flags & GPIO_SINGLE_ENDED));
if (ret < 0) {
return ret;
}
/* Configure pulls */
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_PULLUP + pin,
!!(flags & GPIO_PULL_UP));
if (ret < 0) {
return ret;
}
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_PULLDOWN + pin,
!!(flags & GPIO_PULL_DOWN));
if (ret < 0) {
return ret;
}
/* Configure drive strength and debounce */
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_DRIVE + pin,
!!(flags & NPM1300_GPIO_DRIVE_6MA));
if (ret < 0) {
return ret;
}
ret = mfd_npm1300_reg_write(config->mfd, NPM_GPIO_BASE, NPM_GPIO_OFFSET_DEBOUNCE + pin,
!!(flags & NPM1300_GPIO_DEBOUNCE_ON));
return ret;
}
static int gpio_npm1300_port_toggle_bits(const struct device *dev, gpio_port_pins_t pins)
{
int ret;
uint32_t value;
ret = gpio_npm1300_port_get_raw(dev, &value);
if (ret < 0) {
return ret;
}
return gpio_npm1300_port_set_masked_raw(dev, pins, ~value);
}
static const struct gpio_driver_api gpio_npm1300_api = {
.pin_configure = gpio_npm1300_configure,
.port_get_raw = gpio_npm1300_port_get_raw,
.port_set_masked_raw = gpio_npm1300_port_set_masked_raw,
.port_set_bits_raw = gpio_npm1300_port_set_bits_raw,
.port_clear_bits_raw = gpio_npm1300_port_clear_bits_raw,
.port_toggle_bits = gpio_npm1300_port_toggle_bits,
};
static int gpio_npm1300_init(const struct device *dev)
{
const struct gpio_npm1300_config *config = dev->config;
if (!device_is_ready(config->mfd)) {
return -ENODEV;
}
return 0;
}
#define GPIO_NPM1300_DEFINE(n) \
static const struct gpio_npm1300_config gpio_npm1300_config##n = { \
.common = \
{ \
.port_pin_mask = GPIO_PORT_PIN_MASK_FROM_DT_INST(n), \
}, \
.mfd = DEVICE_DT_GET(DT_INST_PARENT(n))}; \
\
static struct gpio_npm1300_data gpio_npm1300_data##n; \
\
DEVICE_DT_INST_DEFINE(n, &gpio_npm1300_init, NULL, &gpio_npm1300_data##n, \
&gpio_npm1300_config##n, POST_KERNEL, \
CONFIG_GPIO_NPM1300_INIT_PRIORITY, &gpio_npm1300_api);
DT_INST_FOREACH_STATUS_OKAY(GPIO_NPM1300_DEFINE)