blob: 2b524c2bf9d8ed91b25f1603dc269d46270fd769 [file] [log] [blame] [edit]
# I3C configuration options
#
# Copyright (c) 2022 Intel Corporation
#
# SPDX-License-Identifier: Apache-2.0
menuconfig I3C
bool "Improved Inter-Integrated Circuit (I3C) bus drivers"
help
Enable I3C Driver Configuration
if I3C
module = I3C
module-str = i3c
source "subsys/logging/Kconfig.template.log_config"
config I3C_USE_GROUP_ADDR
bool "Use Group Addresses"
default y
help
Enable this to use group addresses if supported
by the controllers and target devices.
Says Y if unsure.
menuconfig I3C_USE_IBI
bool "Use In-Band Interrupt (IBI)"
default y
help
Enable this to use In-Band Interrupt (IBI).
Says Y if unsure.
if I3C_USE_IBI
config I3C_IBI_MAX_PAYLOAD_SIZE
int "Maximum IBI Payload Size"
default 16
help
Maxmium IBI payload size.
menuconfig I3C_IBI_WORKQUEUE
bool "Use IBI Workqueue"
help
Use global workqueue for processing IBI.
This is enabled by driver if needed.
if I3C_IBI_WORKQUEUE
config I3C_IBI_WORKQUEUE_STACK_SIZE
int "IBI workqueue stack size"
default 1024
help
Stack size for the IBI global workqueue.
config I3C_IBI_WORKQUEUE_PRIORITY
int "IBI workqueue thread priority"
default -1
help
Thread priority for the IBI global workqueue.
config I3C_IBI_WORKQUEUE_LENGTH
int "IBI workqueue queue length"
default 8
help
Define the maximum number of IBIs that can be
queued in the workqueue.
config I3C_IBI_WORKQUEUE_VERBOSE_DEBUG
bool "Verbose debug messages for IBI workqueue"
help
This turns on verbose debug for the IBI workqueue
when logging level is set to DEBUG, and prints
the IBI payload.
endif # I3C_IBI_WORKQUEUE
endif # I3C_USE_IBI
comment "Initialization Priority"
config I3C_CONTROLLER_INIT_PRIORITY
int "I3C Controller Init Priority"
# Default is just after CONFIG_KERNEL_INIT_PRIORITY_DEVICE
default 50
help
This is for setting up I3C controller device driver instance
and also to perform bus initialization (e.g. dynamic address
assignment).
Note that this needs to be done before the device driver
instances of the connected I2C and I3C devices start
initializing those devices. This is because some devices
may not be addressable until addresses are assigned by
the controller.
comment "Device Drivers"
rsource "Kconfig.nxp"
rsource "Kconfig.cdns"
rsource "Kconfig.test"
endif # I3C