| .. _m5stack_core2: |
| |
| M5Stack Core2 |
| ############# |
| |
| Overview |
| ******** |
| |
| M5Stack Core2 is an ESP32-based development board from M5Stack. It is the successor for the Core module. |
| |
| M5Stack Core2 features the following integrated components: |
| |
| - ESP32-D0WDQ6-V3 chip (240MHz dual core, 600 DMIPS, 520KB SRAM, Wi-Fi) |
| - PSRAM 8MB |
| - Flash 16MB |
| - LCD IPS TFT 2", 320x240 px screen (ILI9342C) |
| - Touch screen (FT6336U) |
| - PMU AXP192 |
| - Audio NS4168 amplifier (1W-092 speaker) |
| - Vibration motor |
| - RTC BM8563 |
| - USB CP2104 |
| - SD-Card slot |
| - IMO 6-axis IMU MPU6886 |
| - MIC SPM1423 |
| - Battery 390mAh 3,7V |
| |
| .. figure:: img/m5stack_core2.webp |
| :align: center |
| :alt: M5Stack-Core2 |
| :width: 400 px |
| |
| M5Stack-Core2 module |
| |
| Functional Description |
| ********************** |
| |
| The following table below describes the key components, interfaces, and controls |
| of the M5Stack Core2 board. |
| |
| .. _M5Core2 Schematic: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/schematic/Core/CORE2_V1.0_SCH.pdf |
| .. _MPU-ESP32: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/esp32_datasheet_en_v3.9.pdf |
| .. _TOUCH-FT6336U: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/Ft6336GU_Firmware%20外部寄存器_20151112-%20EN.xlsx |
| .. _SND-NS4168: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/NS4168_CN_datasheet.pdf |
| .. _MPU-6886: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/MPU-6886-000193%2Bv1.1_GHIC_en.pdf |
| .. _LCD-ILI9342C: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/ILI9342C-ILITEK.pdf |
| .. _SPM-1423: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/SPM1423HM4H-B_datasheet_en.pdf |
| .. _RTC-BM8563: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/BM8563_V1.1_cn.pdf |
| .. _SY7088: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/SY7088-Silergy.pdf |
| .. _PMU-AXP192: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/AXP192_datasheet_en.pdf |
| .. _VIB-1072_RFN01: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/1027RFN01-33d.pdf |
| |
| +------------------+--------------------------------------------------------------------------+------------+ |
| | Key Component | Description | Status | |
| +==================+==========================================================================+============+ |
| || ESP32-D0WDQ6-V2 || This `MPU-ESP32`_ module provides complete Wi-Fi and Bluetooth || supported | |
| || module || functionalities and integrates a 16-MB SPI flash. || | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| || 32.768 kHz RTC || External precision 32.768 kHz crystal oscillator serves as a clock with || supported | |
| || || low-power consumption while the chip is in Deep-sleep mode. || | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| | Status LED | One user LED connected to the GPIO pin. | supported | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| || USB Port || USB interface. Power supply for the board as well as the || supported | |
| || || communication interface between a computer and the board. || | |
| || || Contains: TypeC x 1, GROVE(I2C+I/O+UART) x 1 || | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| | Reset button | Reset button | supported | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| | Power Switch | Power on/off button. | supported | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| || LCD screen || Built-in LCD TFT display \(`LCD-ILI9342C`_, 2", 320x240 px\) || supported | |
| || || controlled via SPI interface || | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| | SD-Card slot | SD-Card connection via SPI-mode. | supported | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| || 6-axis IMU || The `MPU-6886`_ is a 6-axis motion tracker (6DOF IMU) device that || todo | |
| || MPU6886 || combines a 3-axis gyroscope and a 3-axis accelerometer. || | |
| || || For details please refer to :ref:`m5stack_core2_ext` || | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| || Built-in || The `SPM-1423`_ I2S driven microphone. || todo | |
| || microphone || || | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| | Built-in speaker | 1W speaker for audio output via I2S interface. | todo | |
| +------------------+--------------------------------------------------------------------------+------------+ |
| |
| Supported Features |
| ================== |
| |
| The Zephyr m5stack_core2 board configuration supports the following hardware features: |
| |
| +-----------+------------+-------------------------------------+ |
| | Interface | Controller | Driver/Component | |
| +===========+============+=====================================+ |
| | NVIC | on-chip | nested vector interrupt controller | |
| +-----------+------------+-------------------------------------+ |
| | UART | on-chip | serial port-polling; | |
| | | | serial port-interrupt | |
| +-----------+------------+-------------------------------------+ |
| | PINMUX | on-chip | pinmux | |
| +-----------+------------+-------------------------------------+ |
| | GPIO | on-chip | gpio | |
| +-----------+------------+-------------------------------------+ |
| | I2C | on-chip | i2c | |
| +-----------+------------+-------------------------------------+ |
| | SPI | on-chip | spi | |
| +-----------+------------+-------------------------------------+ |
| | CLOCK | on-chip | reset and clock control | |
| +-----------+------------+-------------------------------------+ |
| | COUNTER | on-chip | rtc | |
| +-----------+------------+-------------------------------------+ |
| | WATCHDOG | on-chip | independent watchdog | |
| +-----------+------------+-------------------------------------+ |
| | PWM | on-chip | pwm | |
| +-----------+------------+-------------------------------------+ |
| | ADC | on-chip | adc | |
| +-----------+------------+-------------------------------------+ |
| | DAC | on-chip | dac | |
| +-----------+------------+-------------------------------------+ |
| | die-temp | on-chip | die temperature sensor | |
| +-----------+------------+-------------------------------------+ |
| |
| |
| Start Application Development |
| ***************************** |
| |
| Before powering up your M5Stack Core2, please make sure that the board is in good |
| condition with no obvious signs of damage. |
| |
| System requirements |
| =================== |
| |
| Prerequisites |
| ------------- |
| |
| Espressif HAL requires WiFi and Bluetooth binary blobs in order work. Run the command |
| below to retrieve those files. |
| |
| .. code-block:: console |
| |
| west blobs fetch hal_espressif |
| |
| .. note:: |
| |
| It is recommended running the command above after :file:`west update`. |
| |
| Building & Flashing |
| ------------------- |
| |
| Build and flash applications as usual (see :ref:`build_an_application` and |
| :ref:`application_run` for more details). |
| |
| .. zephyr-app-commands:: |
| :zephyr-app: samples/hello_world |
| :board: m5stack_core2 |
| :goals: build |
| |
| The usual ``flash`` target will work with the ``m5stack_core2`` board |
| configuration. Here is an example for the :ref:`hello_world` |
| application. |
| |
| .. zephyr-app-commands:: |
| :zephyr-app: samples/hello_world |
| :board: m5stack_core2 |
| :goals: flash |
| |
| The baud rate of 921600bps is set by default. If experiencing issues when flashing, |
| try using different values by using ``--esp-baud-rate <BAUD>`` option during |
| ``west flash`` (e.g. ``west flash --esp-baud-rate 115200``). |
| |
| You can also open the serial monitor using the following command: |
| |
| .. code-block:: shell |
| |
| west espressif monitor |
| |
| After the board has automatically reset and booted, you should see the following |
| message in the monitor: |
| |
| .. code-block:: console |
| |
| ***** Booting Zephyr OS vx.x.x-xxx-gxxxxxxxxxxxx ***** |
| Hello World! m5stack_core2 |
| |
| Debugging |
| --------- |
| |
| M5Stack Core2 debugging is not supported due to pinout limitations. |
| |
| Related Documents |
| ***************** |
| |
| - `M5StickC PLUS schematic <https://static-cdn.m5stack.com/resource/docs/products/core/m5stickc_plus/m5stickc_plus_sch_03.webp>`_ (WEBP) |
| - `ESP32-PICO-D4 Datasheet <https://www.espressif.com/sites/default/files/documentation/esp32-pico-d4_datasheet_en.pdf>`_ (PDF) |
| - `M5StickC PLUS docs <https://docs.m5stack.com/en/core/m5stickc_plus>`_ |
| - `ESP32 Datasheet <https://www.espressif.com/sites/default/files/documentation/esp32_datasheet_en.pdf>`_ (PDF) |
| - `ESP32 Hardware Reference <https://docs.espressif.com/projects/esp-idf/en/latest/esp32/hw-reference/index.html>`_ |