arch/arm/soc/st_stm32/stm32f4/soc.c

/*
 * Copyright (c) 2016 Open-RnD Sp. z o.o.
 * Copyright (c) 2016 Linaro Limited.
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

/**
 * @file
 * @brief System/hardware module for STM32F4 processor
 */

#include <nanokernel.h>
#include <device.h>
#include <init.h>
#include <soc.h>
#include <arch/cpu.h>

/**
 * @brief Perform basic hardware initialization at boot.
 *
 * This needs to be run from the very beginning.
 * So the init priority has to be 0 (zero).
 *
 * @return 0
 */
static int st_stm32f4_init(struct device *arg)
{
	uint32_t key;

	ARG_UNUSED(arg);

	key = irq_lock();

	/* Setup the vector table offset register (VTOR),
	 * which is located at the beginning of flash area.
	 */
	_scs_relocate_vector_table((void *)CONFIG_FLASH_BASE_ADDRESS);

	/* Clear all faults */
	_ScbMemFaultAllFaultsReset();
	_ScbBusFaultAllFaultsReset();
	_ScbUsageFaultAllFaultsReset();

	_ScbHardFaultAllFaultsReset();

	/* Install default handler that simply resets the CPU
	 * if configured in the kernel, NOP otherwise
	 */
	NMI_INIT();

	irq_unlock(key);

	return 0;
}

SYS_INIT(st_stm32f4_init, PRE_KERNEL_1, 0);