| # Kconfig - TI LM3S6965 platform configuration options |
| |
| # |
| # Copyright (c) 2014-2015 Wind River Systems, Inc. |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| # |
| |
| if SOC_TI_LM3S6965 |
| |
| config SOC |
| default ti_lm3s6965 |
| |
| config SRAM_BASE_ADDRESS |
| default 0x20000000 |
| |
| config FLASH_BASE_ADDRESS |
| default 0x00000000 |
| |
| config NUM_IRQ_PRIO_BITS |
| int |
| default 3 |
| |
| config NUM_IRQS |
| int |
| # must be >= the highest interrupt number used |
| # - include the UART interrupts |
| default 34 |
| |
| config SYS_CLOCK_HW_CYCLES_PER_SEC |
| int |
| default 12000000 |
| |
| if UART_STELLARIS |
| |
| config UART_STELLARIS_PORT_0 |
| def_bool y |
| |
| if UART_STELLARIS_PORT_0 |
| config UART_STELLARIS_PORT_0_IRQ_PRI |
| default 3 |
| config UART_STELLARIS_PORT_0_BAUD_RATE |
| default 115200 |
| endif |
| |
| config UART_STELLARIS_PORT_1 |
| def_bool y |
| |
| if UART_STELLARIS_PORT_1 |
| config UART_STELLARIS_PORT_1_IRQ_PRI |
| default 3 |
| config UART_STELLARIS_PORT_1_BAUD_RATE |
| default 115200 |
| endif |
| |
| config UART_STELLARIS_PORT_2 |
| def_bool y |
| if UART_STELLARIS_PORT_2 |
| config UART_STELLARIS_PORT_2_IRQ_PRI |
| default 3 |
| config UART_STELLARIS_PORT_2_BAUD_RATE |
| default 115200 |
| endif |
| |
| endif # UART_STELLARIS |
| |
| config BLUETOOTH_UART_ON_DEV_NAME |
| default "UART_1" if BLUETOOTH_UART |
| |
| config UART_PIPE_ON_DEV_NAME |
| default "UART_2" if UART_PIPE |
| |
| config BLUETOOTH_MONITOR_ON_DEV_NAME |
| default "UART_2" if BLUETOOTH_DEBUG_MONITOR |
| |
| endif |