| .. _blink-led-sample: |
| |
| PWM: Blink LED |
| ############## |
| |
| Overview |
| ******** |
| |
| This is a sample app which blinks a LED using PWM. |
| |
| The LED will start at a blinking frequency of 1 Hz. Every 4 seconds, |
| the blinking frequency will double. When the blinking frequency |
| reaches 64 Hz, the blinking frequency will be halved every 4 seconds |
| until the blinking frequency reaches 1 Hz. This completes a whole |
| blinking cycle. This faster-then-slower LED blinking cycle repeats forever. |
| |
| Wiring |
| ****** |
| |
| Nucleo_F401RE, Nucleo_L476RG, STM32F4_DISCOVERY, Nucleo_F302R8 |
| ============================================================== |
| Connect PWM2(PA0) to LED |
| |
| Nucleo_F103RB |
| ============= |
| Connect PWM1(PA8) to LED |
| |
| Nucleo_L496ZG |
| ============= |
| No special board setup is necessary because there are three on-board LEDs (red, |
| green, blue) connected to the Nucleo's PWM. |
| |
| Hexiwear K64 |
| ============ |
| No special board setup is necessary because there is an on-board RGB LED |
| connected to the K64 PWM. |
| |
| nrf52840_pca10056 |
| ================= |
| No special board setup is necessary because there is an on-board LED connected. |
| |
| Building and Running |
| ******************** |
| |
| This sample can be built for multiple boards, in this example we will build it |
| for the nrf52840_pca10056 board: |
| |
| .. zephyr-app-commands:: |
| :zephyr-app: samples/basic/blink_led |
| :board: nrf52840_pca10056 |
| :goals: build flash |
| :compact: |
| |
| After flashing the image to the board, the user LED on the board should start to |
| blinking as discussed in overview |
| |
