| # USB-KW24D512 board |
| |
| # Copyright (c) 2017, Phytec Messtechnik GmbH |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| if BOARD_USB_KW24D512 |
| |
| config BOARD |
| default "usb_kw24d512" |
| |
| config OSC_XTAL0_FREQ |
| # The MCU is configured to use 4 MHz external |
| # clock from the transceiver provided at the CLK_OUT output. |
| # CLK_OUT is internally connected to the input pin EXTAL0 |
| # of the MCU. |
| default 4000000 |
| |
| config MCG_PRDIV0 |
| default 0x1 |
| |
| config MCG_VDIV0 |
| default 0x0 |
| |
| config MCG_FCRDIV |
| default 2 |
| |
| config UART_MCUX_0 |
| default y |
| depends on UART_MCUX |
| |
| if PINMUX_MCUX |
| |
| config PINMUX_MCUX_PORTA |
| default y if UART_MCUX_0 |
| |
| config PINMUX_MCUX_PORTB |
| default y if SPI_1 |
| |
| config PINMUX_MCUX_PORTC |
| default y |
| |
| config PINMUX_MCUX_PORTD |
| default y |
| |
| endif # PINMUX_MCUX |
| |
| if GPIO_MCUX |
| |
| config GPIO_MCUX_PORTA |
| default y |
| |
| config GPIO_MCUX_PORTB |
| default y |
| |
| config GPIO_MCUX_PORTC |
| default y |
| |
| config GPIO_MCUX_PORTD |
| default y |
| |
| config GPIO_MCUX_PORTE |
| default y |
| |
| endif # GPIO_MCUX |
| |
| if I2C |
| |
| config I2C_0 |
| default y |
| |
| config I2C_1 |
| default n |
| |
| endif # I2C |
| |
| config ADC_0 |
| default y |
| depends on ADC |
| |
| config PWM_1 |
| default y |
| depends on PWM_MCUX_FTM |
| |
| config SPI_1 |
| default y |
| depends on SPI |
| |
| config MCR20A_IS_PART_OF_KW2XD_SIP |
| default y |
| depends on IEEE802154_MCR20A |
| |
| endif # BOARD_USB_KW24D512 |
