| # nRF5340 PDK board configuration |
| |
| # Copyright (c) 2019 Nordic Semiconductor ASA |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| if BOARD_NRF5340PDK_NRF5340_CPUAPP || BOARD_NRF5340PDK_NRF5340_CPUAPPNS |
| |
| config BOARD_ENABLE_DCDC_APP |
| bool "Enable Application MCU DCDC converter" |
| select SOC_DCDC_NRF53X_APP |
| default y |
| |
| config BOARD_ENABLE_DCDC_NET |
| bool "Enable Network MCU DCDC converter" |
| select SOC_DCDC_NRF53X_NET |
| default y |
| |
| config BOARD_ENABLE_DCDC_HV |
| bool "Enable High Voltage DCDC converter" |
| select SOC_DCDC_NRF53X_HV |
| default y |
| |
| choice BT_HCI_BUS_TYPE |
| default BT_RPMSG if BT |
| endchoice |
| |
| config HEAP_MEM_POOL_SIZE |
| default 4096 if BT_RPMSG |
| |
| config BT_HAS_HCI_VS |
| default y if BT |
| |
| config BOARD_ENABLE_CPUNET |
| bool "Enable nRF53 Network MCU" |
| help |
| This option enables releasing the Network 'force off' signal, which |
| as a consequence will power up the Network MCU during system boot. |
| Additionally, the option allocates GPIO pins that will be used by UARTE |
| of the Network MCU. |
| Note: The non-secure image can only be started by the secure firmware, |
| so when this option is used with the non-secure version of the board, |
| the application needs to take into consideration, that the secure firmware |
| may already have started the Network MCU. |
| default y if (BT || NET_L2_IEEE802154) |
| |
| endif # BOARD_NRF5340PDK_NRF5340_CPUAPP || BOARD_NRF5340PDK_NRF5340_CPUAPPNS |
| |
| if BOARD_NRF5340PDK_NRF5340_CPUNET |
| |
| # BT_CTLR depends on BT. When BT is enabled we should default to also |
| # enabling the controller. |
| config BT_CTLR |
| default y if BT |
| |
| config BT_ECC |
| default y if BT |
| |
| endif # BOARD_NRF5340PDK_NRF5340_CPUNET |
