blob: 8c359e41f14b60a32c0396fd20614595ee00155a [file] [log] [blame]
# NXP MCR20A configuration options
# Copyright (c) 2017 PHYTEC Messtechnik GmbH
# SPDX-License-Identifier: Apache-2.0
menuconfig IEEE802154_MCR20A
bool "NXP MCR20A Driver support"
depends on NETWORKING && SPI
if IEEE802154_MCR20A
config IEEE802154_MCR20A_DRV_NAME
string "NXP MCR20A Driver's name"
default "mcr20a"
help
This option sets the driver name
config MCR20A_IS_PART_OF_KW2XD_SIP
bool "MCR20A device is part of KW2xD SiP"
help
If this option is set, the driver does not perform a hardware
reset and the CLK_OUT frequency is not set, instead these settings
are performed during the initialization of the SoC.
choice
prompt "CLK_OUT frequency"
default MCR20A_CLK_OUT_4MHZ if MCR20A_IS_PART_OF_KW2XD_SIP
default MCR20A_CLK_OUT_DISABLED
help
Configuration of the MCR20A clock output pin.
config MCR20A_CLK_OUT_DISABLED
bool "Disabled"
config MCR20A_CLK_OUT_32MHZ
bool "32 MHz"
config MCR20A_CLK_OUT_16MHZ
bool "16 MHz"
config MCR20A_CLK_OUT_8MHZ
bool "8 MHz"
config MCR20A_CLK_OUT_4MHZ
bool "4 MHz"
config MCR20A_CLK_OUT_1MHZ
bool "1 MHz"
config MCR20A_CLK_OUT_250KHZ
bool "250 kHz"
config MCR20A_CLK_OUT_62500HZ
bool "62500 Hz"
config MCR20A_CLK_OUT_32768HZ
bool "32768 Hz"
endchoice
config IEEE802154_MCR20A_RX_STACK_SIZE
int "Driver's internal RX thread stack size"
default 800
help
This option sets the driver's stack size for its internal RX thread.
The default value should be sufficient, but in case it proves to be
a too little one, this option makes it easy to play with the size.
config IEEE802154_MCR20A_INIT_PRIO
int "MCR20A initialization priority"
default 80
help
Set the initialization priority number. Do not mess with it unless
you know what you are doing. Beware mcr20a requires gpio and spi to
be ready first (and sometime gpio should be the very first as spi
might need it too). And of course it has to start before the net stack.
endif