boards/arm/frdm_k22f/pinmux.c

/*
 * Copyright (c) 2018 Prevas A/S
 *
 * SPDX-License-Identifier: Apache-2.0
 */

#include <init.h>
#include <drivers/pinmux.h>
#include <fsl_port.h>

static int frdm_k22f_pinmux_init(const struct device *dev)
{
	ARG_UNUSED(dev);

#if DT_NODE_HAS_STATUS(DT_NODELABEL(porta), okay)
	__unused const struct device *porta =
		device_get_binding(DT_LABEL(DT_NODELABEL(porta)));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(portb), okay)
	__unused const struct device *portb =
		device_get_binding(DT_LABEL(DT_NODELABEL(portb)));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(portc), okay)
	__unused const struct device *portc =
		device_get_binding(DT_LABEL(DT_NODELABEL(portc)));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(portd), okay)
	__unused const struct device *portd =
		device_get_binding(DT_LABEL(DT_NODELABEL(portd)));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(porte), okay)
	__unused const struct device *porte =
		device_get_binding(DT_LABEL(DT_NODELABEL(porte)));
#endif

#if DT_NODE_HAS_STATUS(DT_NODELABEL(uart0), okay) && CONFIG_SERIAL
#error "No UART0 is used"
#endif

#if DT_NODE_HAS_STATUS(DT_NODELABEL(uart1), okay) && CONFIG_SERIAL
	/* UART1 RX, TX */
	pinmux_pin_set(porte, 0, PORT_PCR_MUX(kPORT_MuxAlt3));
	pinmux_pin_set(porte, 1, PORT_PCR_MUX(kPORT_MuxAlt3));
#endif

#if DT_NODE_HAS_STATUS(DT_NODELABEL(uart2), okay) && CONFIG_SERIAL
	/* UART2 RX, TX */
	pinmux_pin_set(portd, 2, PORT_PCR_MUX(kPORT_MuxAlt3));
	pinmux_pin_set(portd, 3, PORT_PCR_MUX(kPORT_MuxAlt3));
#endif

	/* SW2 */
	pinmux_pin_set(portc, 1, PORT_PCR_MUX(kPORT_MuxAsGpio));
	/* SW3 */
	pinmux_pin_set(portb, 17, PORT_PCR_MUX(kPORT_MuxAsGpio));

	/* FXOS8700 INT1 */
	pinmux_pin_set(portd, 0, PORT_PCR_MUX(kPORT_MuxAsGpio));
	/* FXOS8700 INT2 */
	pinmux_pin_set(portd, 1, PORT_PCR_MUX(kPORT_MuxAsGpio));

	/* Red, green, blue LEDs */
	pinmux_pin_set(porta, 1, PORT_PCR_MUX(kPORT_MuxAsGpio));
	pinmux_pin_set(porta, 2, PORT_PCR_MUX(kPORT_MuxAsGpio));
	pinmux_pin_set(portd, 5, PORT_PCR_MUX(kPORT_MuxAsGpio));

#if DT_NODE_HAS_STATUS(DT_NODELABEL(spi0), okay) && CONFIG_SPI
	/* SPI0 CS0, SCK, SOUT, SIN */
	pinmux_pin_set(portd, 4, PORT_PCR_MUX(kPORT_MuxAlt2));
	pinmux_pin_set(portd, 1, PORT_PCR_MUX(kPORT_MuxAlt2));
	pinmux_pin_set(portd, 2, PORT_PCR_MUX(kPORT_MuxAlt2));
	pinmux_pin_set(portd, 3, PORT_PCR_MUX(kPORT_MuxAlt2));
	pinmux_pin_set(portc, 11, PORT_PCR_MUX(kPORT_MuxAsGpio));
#endif

#if DT_NODE_HAS_STATUS(DT_NODELABEL(i2c0), okay) && CONFIG_I2C
	/* I2C0 SCL, SDA */
	pinmux_pin_set(portb, 2, PORT_PCR_MUX(kPORT_MuxAlt2)
					| PORT_PCR_ODE_MASK);
	pinmux_pin_set(portb, 3, PORT_PCR_MUX(kPORT_MuxAlt2)
					| PORT_PCR_ODE_MASK);
#endif

	return 0;
}

SYS_INIT(frdm_k22f_pinmux_init, PRE_KERNEL_1, CONFIG_PINMUX_INIT_PRIORITY);