blob: bdc414830cb04f20d68d8e298797077145b7a78e [file] [log] [blame]
/*
* Copyright (c) 2017 Piotr Mienkowski
*
* SPDX-License-Identifier: Apache-2.0
*/
#define DT_DRV_COMPAT atmel_sam_i2c_twi
/** @file
* @brief I2C bus (TWI) driver for Atmel SAM MCU family.
*
* Limitations:
* - Only I2C Master Mode with 7 bit addressing is currently supported.
* - No reentrancy support.
*/
#include <errno.h>
#include <sys/__assert.h>
#include <stdbool.h>
#include <kernel.h>
#include <device.h>
#include <init.h>
#include <soc.h>
#include <drivers/i2c.h>
#define LOG_LEVEL CONFIG_I2C_LOG_LEVEL
#include <logging/log.h>
LOG_MODULE_REGISTER(i2c_sam_twi);
#include "i2c-priv.h"
/** I2C bus speed [Hz] in Standard Mode */
#define BUS_SPEED_STANDARD_HZ 100000U
/** I2C bus speed [Hz] in Fast Mode */
#define BUS_SPEED_FAST_HZ 400000U
/* Maximum value of Clock Divider (CKDIV) */
#define CKDIV_MAX 7
/* Device constant configuration parameters */
struct i2c_sam_twi_dev_cfg {
Twi *regs;
void (*irq_config)(void);
uint32_t bitrate;
const struct soc_gpio_pin *pin_list;
uint8_t pin_list_size;
uint8_t periph_id;
uint8_t irq_id;
};
struct twi_msg {
/* Buffer containing data to read or write */
uint8_t *buf;
/* Length of the buffer */
uint32_t len;
/* Index of the next byte to be read/written from/to the buffer */
uint32_t idx;
/* Value of TWI_SR at the end of the message */
uint32_t twi_sr;
/* Transfer flags as defined in the i2c.h file */
uint8_t flags;
};
/* Device run time data */
struct i2c_sam_twi_dev_data {
struct k_sem sem;
struct twi_msg msg;
};
#define DEV_NAME(dev) ((dev)->name)
#define DEV_CFG(dev) \
((const struct i2c_sam_twi_dev_cfg *const)(dev)->config)
#define DEV_DATA(dev) \
((struct i2c_sam_twi_dev_data *const)(dev)->data)
static int i2c_clk_set(Twi *const twi, uint32_t speed)
{
uint32_t ck_div = 0U;
uint32_t cl_div;
bool div_completed = false;
/* From the datasheet "TWI Clock Waveform Generator Register"
* T_low = ( ( CLDIV × 2^CKDIV ) + 4 ) × T_MCK
*/
while (!div_completed) {
cl_div = ((SOC_ATMEL_SAM_MCK_FREQ_HZ / (speed * 2U)) - 4)
/ (1 << ck_div);
if (cl_div <= 255U) {
div_completed = true;
} else {
ck_div++;
}
}
if (ck_div > CKDIV_MAX) {
LOG_ERR("Failed to configure I2C clock");
return -EIO;
}
/* Set TWI clock duty cycle to 50% */
twi->TWI_CWGR = TWI_CWGR_CLDIV(cl_div) | TWI_CWGR_CHDIV(cl_div)
| TWI_CWGR_CKDIV(ck_div);
return 0;
}
static int i2c_sam_twi_configure(const struct device *dev, uint32_t config)
{
const struct i2c_sam_twi_dev_cfg *const dev_cfg = DEV_CFG(dev);
Twi *const twi = dev_cfg->regs;
uint32_t bitrate;
int ret;
if (!(config & I2C_MODE_MASTER)) {
LOG_ERR("Master Mode is not enabled");
return -EIO;
}
if (config & I2C_ADDR_10_BITS) {
LOG_ERR("I2C 10-bit addressing is currently not supported");
LOG_ERR("Please submit a patch");
return -EIO;
}
/* Configure clock */
switch (I2C_SPEED_GET(config)) {
case I2C_SPEED_STANDARD:
bitrate = BUS_SPEED_STANDARD_HZ;
break;
case I2C_SPEED_FAST:
bitrate = BUS_SPEED_FAST_HZ;
break;
default:
LOG_ERR("Unsupported I2C speed value");
return -EIO;
}
/* Setup clock waveform */
ret = i2c_clk_set(twi, bitrate);
if (ret < 0) {
return ret;
}
/* Disable Slave Mode */
twi->TWI_CR = TWI_CR_SVDIS;
/* Enable Master Mode */
twi->TWI_CR = TWI_CR_MSEN;
return 0;
}
static void write_msg_start(Twi *const twi, struct twi_msg *msg, uint8_t daddr)
{
/* Set slave address and number of internal address bytes. */
twi->TWI_MMR = TWI_MMR_DADR(daddr);
/* Write first data byte on I2C bus */
twi->TWI_THR = msg->buf[msg->idx++];
/* Enable Transmit Ready and Transmission Completed interrupts */
twi->TWI_IER = TWI_IER_TXRDY | TWI_IER_TXCOMP | TWI_IER_NACK;
}
static void read_msg_start(Twi *const twi, struct twi_msg *msg, uint8_t daddr)
{
uint32_t twi_cr_stop;
/* Set slave address and number of internal address bytes */
twi->TWI_MMR = TWI_MMR_MREAD | TWI_MMR_DADR(daddr);
/* In single data byte read the START and STOP must both be set */
twi_cr_stop = (msg->len == 1U) ? TWI_CR_STOP : 0;
/* Start the transfer by sending START condition */
twi->TWI_CR = TWI_CR_START | twi_cr_stop;
/* Enable Receive Ready and Transmission Completed interrupts */
twi->TWI_IER = TWI_IER_RXRDY | TWI_IER_TXCOMP | TWI_IER_NACK;
}
static int i2c_sam_twi_transfer(const struct device *dev,
struct i2c_msg *msgs,
uint8_t num_msgs, uint16_t addr)
{
const struct i2c_sam_twi_dev_cfg *const dev_cfg = DEV_CFG(dev);
struct i2c_sam_twi_dev_data *const dev_data = DEV_DATA(dev);
Twi *const twi = dev_cfg->regs;
__ASSERT_NO_MSG(msgs);
if (!num_msgs) {
return 0;
}
/* Clear pending interrupts, such as NACK. */
(void)twi->TWI_SR;
/* Set number of internal address bytes to 0, not used. */
twi->TWI_IADR = 0;
for (; num_msgs > 0; num_msgs--, msgs++) {
dev_data->msg.buf = msgs->buf;
dev_data->msg.len = msgs->len;
dev_data->msg.idx = 0U;
dev_data->msg.twi_sr = 0U;
dev_data->msg.flags = msgs->flags;
/*
* REMARK: Dirty workaround:
*
* The controller does not have a documented, generic way to
* issue RESTART when changing transfer direction as master.
* Send a stop condition in such a case.
*/
if (num_msgs > 1) {
if ((msgs[0].flags & I2C_MSG_RW_MASK) !=
(msgs[1].flags & I2C_MSG_RW_MASK)) {
dev_data->msg.flags |= I2C_MSG_STOP;
}
}
if ((msgs->flags & I2C_MSG_RW_MASK) == I2C_MSG_READ) {
read_msg_start(twi, &dev_data->msg, addr);
} else {
write_msg_start(twi, &dev_data->msg, addr);
}
/* Wait for the transfer to complete */
k_sem_take(&dev_data->sem, K_FOREVER);
if (dev_data->msg.twi_sr > 0) {
/* Something went wrong */
return -EIO;
}
}
return 0;
}
static void i2c_sam_twi_isr(const struct device *dev)
{
const struct i2c_sam_twi_dev_cfg *const dev_cfg = DEV_CFG(dev);
struct i2c_sam_twi_dev_data *const dev_data = DEV_DATA(dev);
Twi *const twi = dev_cfg->regs;
struct twi_msg *msg = &dev_data->msg;
uint32_t isr_status;
/* Retrieve interrupt status */
isr_status = twi->TWI_SR & twi->TWI_IMR;
/* Not Acknowledged */
if (isr_status & TWI_SR_NACK) {
msg->twi_sr = isr_status;
goto tx_comp;
}
/* Byte received */
if (isr_status & TWI_SR_RXRDY) {
msg->buf[msg->idx++] = twi->TWI_RHR;
if (msg->idx == msg->len - 1U) {
/* Send a STOP condition on the TWI */
twi->TWI_CR = TWI_CR_STOP;
}
}
/* Byte sent */
if (isr_status & TWI_SR_TXRDY) {
if (msg->idx == msg->len) {
if (msg->flags & I2C_MSG_STOP) {
/* Send a STOP condition on the TWI */
twi->TWI_CR = TWI_CR_STOP;
/* Disable Transmit Ready interrupt */
twi->TWI_IDR = TWI_IDR_TXRDY;
} else {
/* Transmission completed */
goto tx_comp;
}
} else {
twi->TWI_THR = msg->buf[msg->idx++];
}
}
/* Transmission completed */
if (isr_status & TWI_SR_TXCOMP) {
goto tx_comp;
}
return;
tx_comp:
/* Disable all enabled interrupts */
twi->TWI_IDR = twi->TWI_IMR;
/* We are done */
k_sem_give(&dev_data->sem);
}
static int i2c_sam_twi_initialize(const struct device *dev)
{
const struct i2c_sam_twi_dev_cfg *const dev_cfg = DEV_CFG(dev);
struct i2c_sam_twi_dev_data *const dev_data = DEV_DATA(dev);
Twi *const twi = dev_cfg->regs;
uint32_t bitrate_cfg;
int ret;
/* Configure interrupts */
dev_cfg->irq_config();
/* Initialize semaphore */
k_sem_init(&dev_data->sem, 0, 1);
/* Connect pins to the peripheral */
soc_gpio_list_configure(dev_cfg->pin_list, dev_cfg->pin_list_size);
/* Enable module's clock */
soc_pmc_peripheral_enable(dev_cfg->periph_id);
/* Reset TWI module */
twi->TWI_CR = TWI_CR_SWRST;
bitrate_cfg = i2c_map_dt_bitrate(dev_cfg->bitrate);
ret = i2c_sam_twi_configure(dev, I2C_MODE_MASTER | bitrate_cfg);
if (ret < 0) {
LOG_ERR("Failed to initialize %s device", DEV_NAME(dev));
return ret;
}
/* Enable module's IRQ */
irq_enable(dev_cfg->irq_id);
LOG_INF("Device %s initialized", DEV_NAME(dev));
return 0;
}
static const struct i2c_driver_api i2c_sam_twi_driver_api = {
.configure = i2c_sam_twi_configure,
.transfer = i2c_sam_twi_transfer,
};
#define I2C_TWI_SAM_INIT(n) \
static void i2c##n##_sam_irq_config(void) \
{ \
IRQ_CONNECT(DT_INST_IRQN(n), DT_INST_IRQ(n, priority), \
i2c_sam_twi_isr, \
DEVICE_DT_INST_GET(n), 0); \
} \
\
static const struct soc_gpio_pin pins_twi##n[] = ATMEL_SAM_DT_INST_PINS(n); \
\
static const struct i2c_sam_twi_dev_cfg i2c##n##_sam_config = { \
.regs = (Twi *)DT_INST_REG_ADDR(n), \
.irq_config = i2c##n##_sam_irq_config, \
.periph_id = DT_INST_PROP(n, peripheral_id), \
.irq_id = DT_INST_IRQN(n), \
.pin_list = pins_twi##n, \
.pin_list_size = ARRAY_SIZE(pins_twi##n), \
.bitrate = DT_INST_PROP(n, clock_frequency), \
}; \
\
static struct i2c_sam_twi_dev_data i2c##n##_sam_data; \
\
DEVICE_DT_INST_DEFINE(n, &i2c_sam_twi_initialize, \
NULL, \
&i2c##n##_sam_data, &i2c##n##_sam_config, \
POST_KERNEL, CONFIG_I2C_INIT_PRIORITY, \
&i2c_sam_twi_driver_api);
DT_INST_FOREACH_STATUS_OKAY(I2C_TWI_SAM_INIT)