blob: 86b9ba628181af481a7e36741f7f18d8ba4e8731 [file] [log] [blame]
/*
* Copyright (c) 2017 Google LLC.
* Copyright (c) 2019 Nordic Semiconductor ASA
*
* SPDX-License-Identifier: Apache-2.0
*/
#define DT_DRV_COMPAT atmel_sam0_gpio
#include <errno.h>
#include <device.h>
#include <drivers/gpio.h>
#include <soc.h>
#include <drivers/interrupt_controller/sam0_eic.h>
#include "gpio_utils.h"
#ifndef PORT_PMUX_PMUXE_A_Val
#define PORT_PMUX_PMUXE_A_Val (0)
#endif
struct gpio_sam0_config {
/* gpio_driver_config needs to be first */
struct gpio_driver_config common;
PortGroup *regs;
#ifdef CONFIG_SAM0_EIC
uint8_t id;
#endif
};
struct gpio_sam0_data {
/* gpio_driver_data needs to be first */
struct gpio_driver_data common;
const struct device *dev;
gpio_port_pins_t debounce;
#ifdef CONFIG_SAM0_EIC
sys_slist_t callbacks;
#endif
};
#define DEV_CFG(dev) \
((const struct gpio_sam0_config *const)(dev)->config)
#define DEV_DATA(dev) \
((struct gpio_sam0_data *const)(dev)->data)
#ifdef CONFIG_SAM0_EIC
static void gpio_sam0_isr(uint32_t pins, void *arg)
{
struct gpio_sam0_data *const data = (struct gpio_sam0_data *)arg;
gpio_fire_callbacks(&data->callbacks, data->dev, pins);
}
#endif
static int gpio_sam0_config(const struct device *dev, gpio_pin_t pin,
gpio_flags_t flags)
{
const struct gpio_sam0_config *config = DEV_CFG(dev);
PortGroup *regs = config->regs;
PORT_PINCFG_Type pincfg = {
.reg = 0,
};
if ((flags & GPIO_SINGLE_ENDED) != 0) {
return -ENOTSUP;
}
/* Supports disconnected, input, output, or bidirectional */
if ((flags & GPIO_INPUT) != 0) {
pincfg.bit.INEN = 1;
}
if ((flags & GPIO_OUTPUT) != 0) {
/* Output is incompatible with pull */
if ((flags & (GPIO_PULL_UP | GPIO_PULL_DOWN)) != 0) {
return -ENOTSUP;
}
/* Bidirectional is supported */
if ((flags & GPIO_OUTPUT_INIT_LOW) != 0) {
regs->OUTCLR.reg = BIT(pin);
} else if ((flags & GPIO_OUTPUT_INIT_HIGH) != 0) {
regs->OUTSET.reg = BIT(pin);
}
regs->DIRSET.reg = BIT(pin);
} else {
/* Not output, may be input */
regs->DIRCLR.reg = BIT(pin);
/* Pull configuration is supported if not output */
if ((flags & (GPIO_PULL_UP | GPIO_PULL_DOWN)) != 0) {
pincfg.bit.PULLEN = 1;
if ((flags & GPIO_PULL_UP) != 0) {
regs->OUTSET.reg = BIT(pin);
} else {
regs->OUTCLR.reg = BIT(pin);
}
}
}
/* Preserve debounce flag for interrupt configuration. */
WRITE_BIT(DEV_DATA(dev)->debounce, pin,
((flags & GPIO_INT_DEBOUNCE) != 0)
&& (pincfg.bit.INEN != 0));
/* Write the now-built pin configuration */
regs->PINCFG[pin] = pincfg;
return 0;
}
static int gpio_sam0_port_get_raw(const struct device *dev,
gpio_port_value_t *value)
{
const struct gpio_sam0_config *config = DEV_CFG(dev);
*value = config->regs->IN.reg;
return 0;
}
static int gpio_sam0_port_set_masked_raw(const struct device *dev,
gpio_port_pins_t mask,
gpio_port_value_t value)
{
const struct gpio_sam0_config *config = DEV_CFG(dev);
uint32_t out = config->regs->OUT.reg;
config->regs->OUT.reg = (out & ~mask) | (value & mask);
return 0;
}
static int gpio_sam0_port_set_bits_raw(const struct device *dev,
gpio_port_pins_t pins)
{
const struct gpio_sam0_config *config = DEV_CFG(dev);
config->regs->OUTSET.reg = pins;
return 0;
}
static int gpio_sam0_port_clear_bits_raw(const struct device *dev,
gpio_port_pins_t pins)
{
const struct gpio_sam0_config *config = DEV_CFG(dev);
config->regs->OUTCLR.reg = pins;
return 0;
}
static int gpio_sam0_port_toggle_bits(const struct device *dev,
gpio_port_pins_t pins)
{
const struct gpio_sam0_config *config = DEV_CFG(dev);
config->regs->OUTTGL.reg = pins;
return 0;
}
#ifdef CONFIG_SAM0_EIC
static int gpio_sam0_pin_interrupt_configure(const struct device *dev,
gpio_pin_t pin,
enum gpio_int_mode mode,
enum gpio_int_trig trig)
{
const struct gpio_sam0_config *config = DEV_CFG(dev);
struct gpio_sam0_data *const data = DEV_DATA(dev);
PortGroup *regs = config->regs;
PORT_PINCFG_Type pincfg = {
.reg = regs->PINCFG[pin].reg,
};
enum sam0_eic_trigger trigger;
int rc = 0;
data->dev = dev;
switch (mode) {
case GPIO_INT_MODE_DISABLED:
pincfg.bit.PMUXEN = 0;
rc = sam0_eic_disable_interrupt(config->id, pin);
if (rc == -EBUSY) {
/* Ignore diagnostic disabling disabled */
rc = 0;
}
if (rc == 0) {
rc = sam0_eic_release(config->id, pin);
}
break;
case GPIO_INT_MODE_LEVEL:
case GPIO_INT_MODE_EDGE:
/* Enabling interrupts on a pin requires disconnecting
* the pin from the I/O pin controller (PORT) module
* and connecting it to the External Interrupt
* Controller (EIC). This would prevent using the pin
* as an output, so interrupts are only supported if
* the pin is configured as input-only.
*/
if ((pincfg.bit.INEN == 0)
|| ((regs->DIR.reg & BIT(pin)) != 0)) {
rc = -ENOTSUP;
break;
}
/* Transfer control to EIC */
pincfg.bit.PMUXEN = 1;
if ((pin & 1U) != 0) {
regs->PMUX[pin / 2U].bit.PMUXO = PORT_PMUX_PMUXE_A_Val;
} else {
regs->PMUX[pin / 2U].bit.PMUXE = PORT_PMUX_PMUXE_A_Val;
}
switch (trig) {
case GPIO_INT_TRIG_LOW:
trigger = (mode == GPIO_INT_MODE_LEVEL)
? SAM0_EIC_LOW
: SAM0_EIC_FALLING;
break;
case GPIO_INT_TRIG_HIGH:
trigger = (mode == GPIO_INT_MODE_LEVEL)
? SAM0_EIC_HIGH
: SAM0_EIC_RISING;
break;
case GPIO_INT_TRIG_BOTH:
trigger = SAM0_EIC_BOTH;
break;
default:
rc = -EINVAL;
break;
}
if (rc == 0) {
rc = sam0_eic_acquire(config->id, pin, trigger,
(DEV_DATA(dev)->debounce & BIT(pin)) != 0,
gpio_sam0_isr, data);
}
if (rc == 0) {
rc = sam0_eic_enable_interrupt(config->id, pin);
}
break;
default:
rc = -EINVAL;
break;
}
if (rc == 0) {
/* Update the pin configuration */
regs->PINCFG[pin] = pincfg;
}
return rc;
}
static int gpio_sam0_manage_callback(const struct device *dev,
struct gpio_callback *callback, bool set)
{
struct gpio_sam0_data *const data = DEV_DATA(dev);
return gpio_manage_callback(&data->callbacks, callback, set);
}
static uint32_t gpio_sam0_get_pending_int(const struct device *dev)
{
const struct gpio_sam0_config *config = DEV_CFG(dev);
return sam0_eic_interrupt_pending(config->id);
}
#endif
static const struct gpio_driver_api gpio_sam0_api = {
.pin_configure = gpio_sam0_config,
.port_get_raw = gpio_sam0_port_get_raw,
.port_set_masked_raw = gpio_sam0_port_set_masked_raw,
.port_set_bits_raw = gpio_sam0_port_set_bits_raw,
.port_clear_bits_raw = gpio_sam0_port_clear_bits_raw,
.port_toggle_bits = gpio_sam0_port_toggle_bits,
#ifdef CONFIG_SAM0_EIC
.pin_interrupt_configure = gpio_sam0_pin_interrupt_configure,
.manage_callback = gpio_sam0_manage_callback,
.get_pending_int = gpio_sam0_get_pending_int,
#endif
};
static int gpio_sam0_init(const struct device *dev) { return 0; }
/* Port A */
#if DT_NODE_HAS_STATUS(DT_NODELABEL(porta), okay)
static const struct gpio_sam0_config gpio_sam0_config_0 = {
.common = {
.port_pin_mask = GPIO_PORT_PIN_MASK_FROM_DT_INST(0),
},
.regs = (PortGroup *)DT_REG_ADDR(DT_NODELABEL(porta)),
#ifdef CONFIG_SAM0_EIC
.id = 0,
#endif
};
static struct gpio_sam0_data gpio_sam0_data_0;
DEVICE_DT_DEFINE(DT_NODELABEL(porta),
gpio_sam0_init, NULL,
&gpio_sam0_data_0, &gpio_sam0_config_0,
POST_KERNEL, CONFIG_KERNEL_INIT_PRIORITY_DEVICE,
&gpio_sam0_api);
#endif
/* Port B */
#if DT_NODE_HAS_STATUS(DT_NODELABEL(portb), okay)
static const struct gpio_sam0_config gpio_sam0_config_1 = {
.common = {
.port_pin_mask = GPIO_PORT_PIN_MASK_FROM_DT_INST(1),
},
.regs = (PortGroup *)DT_REG_ADDR(DT_NODELABEL(portb)),
#ifdef CONFIG_SAM0_EIC
.id = 1,
#endif
};
static struct gpio_sam0_data gpio_sam0_data_1;
DEVICE_DT_DEFINE(DT_NODELABEL(portb),
gpio_sam0_init, NULL,
&gpio_sam0_data_1, &gpio_sam0_config_1,
POST_KERNEL, CONFIG_KERNEL_INIT_PRIORITY_DEVICE,
&gpio_sam0_api);
#endif
/* Port C */
#if DT_NODE_HAS_STATUS(DT_NODELABEL(portc), okay)
static const struct gpio_sam0_config gpio_sam0_config_2 = {
.common = {
.port_pin_mask = GPIO_PORT_PIN_MASK_FROM_DT_INST(2),
},
.regs = (PortGroup *)DT_REG_ADDR(DT_NODELABEL(portc)),
#ifdef CONFIG_SAM0_EIC
.id = 2,
#endif
};
static struct gpio_sam0_data gpio_sam0_data_2;
DEVICE_DT_DEFINE(DT_NODELABEL(portc),
gpio_sam0_init, NULL,
&gpio_sam0_data_2, &gpio_sam0_config_2,
POST_KERNEL, CONFIG_KERNEL_INIT_PRIORITY_DEVICE,
&gpio_sam0_api);
#endif
/* Port D */
#if DT_NODE_HAS_STATUS(DT_NODELABEL(portd), okay)
static const struct gpio_sam0_config gpio_sam0_config_3 = {
.common = {
.port_pin_mask = GPIO_PORT_PIN_MASK_FROM_DT_INST(3),
},
.regs = (PortGroup *)DT_REG_ADDR(DT_NODELABEL(portd)),
#ifdef CONFIG_SAM0_EIC
.id = 3,
#endif
};
static struct gpio_sam0_data gpio_sam0_data_3;
DEVICE_DT_DEFINE(DT_NODELABEL(portd),
gpio_sam0_init, NULL,
&gpio_sam0_data_3, &gpio_sam0_config_3,
POST_KERNEL, CONFIG_KERNEL_INIT_PRIORITY_DEVICE,
&gpio_sam0_api);
#endif