| # SPDX-License-Identifier: Apache-2.0 |
| |
| CONFIG_SOC_SERIES_STM32H7X=y |
| CONFIG_SOC_STM32H747XX=y |
| |
| # Board config should be specified since there are 2 possible targets |
| CONFIG_BOARD_STM32H747I_DISCO_M7=y |
| |
| # enable pinmux |
| CONFIG_PINMUX=y |
| |
| # enable GPIO |
| CONFIG_GPIO=y |
| |
| # clock configuration |
| CONFIG_CLOCK_CONTROL=y |
| |
| # Clock configuration for Cube Clock control driver |
| CONFIG_CLOCK_STM32_HSE_CLOCK=25000000 |
| CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y |
| |
| # use HSE (bypass) as PLL input |
| CONFIG_CLOCK_STM32_PLL_SRC_HSE=y |
| CONFIG_CLOCK_STM32_HSE_BYPASS=y |
| |
| # produce 400MHz clock at PLL output |
| CONFIG_CLOCK_STM32_PLL_M_DIVISOR=5 |
| CONFIG_CLOCK_STM32_PLL_N_MULTIPLIER=160 |
| CONFIG_CLOCK_STM32_PLL_P_DIVISOR=2 |
| CONFIG_CLOCK_STM32_PLL_Q_DIVISOR=4 |
| CONFIG_CLOCK_STM32_PLL_R_DIVISOR=2 |
| |
| # Enable MPU |
| CONFIG_ARM_MPU=y |
| |
| # Enable HW stack protection |
| CONFIG_HW_STACK_PROTECTION=y |
| |
| # Disable following to assign serial ports to m4 core |
| |
| # enable uart driver |
| CONFIG_SERIAL=y |
| # console |
| CONFIG_CONSOLE=y |
| CONFIG_UART_CONSOLE=y |