blob: 8fee4185189601f52d8c1392a6541799d73851aa [file] [log] [blame]
#
# Copyright (c) 2020 Siddharth Chandrasekaran <siddharth@embedjournal.com>
#
# SPDX-License-Identifier: Apache-2.0
#
menuconfig OSDP
bool "Open Supervised Device Protocol (OSDP) driver"
select RING_BUFFER
imply SERIAL_SUPPORT_INTERRUPT
imply UART_INTERRUPT_DRIVEN
select CRC
help
Add support for Open Supervised Device Protocol (OSDP)
if OSDP
choice
prompt "OSDP Mode of Operation"
config OSDP_MODE_PD
bool "Configure OSDP in Peripheral Device mode"
help
Configure this device to operate as a PD (Peripheral Device)
config OSDP_MODE_CP
bool "Configure OSDP in Control Panel mode"
help
Configure this device to operate as a CP (Control Panel)
endchoice
config OSDP_UART_BAUD_RATE
int "OSDP UART baud rate"
default 115200
help
OSDP defines that baud rate can be either 9600 or 38400 or
115200.
config OSDP_LOG_LEVEL
int "OSDP Logging Level"
default 1
help
Set the logging level for the OSDP driver
config OSDP_UART_BUFFER_LENGTH
int "OSDP UART buffer length"
default 256
help
OSDP RX and TX buffer FIFO length.
config OSDP_THREAD_STACK_SIZE
int "OSDP Thread stack size"
default 1024
help
Thread stack size for osdp refresh thread
config OSDP_PACKET_TRACE
bool "Print bytes sent/received over OSDP to console"
help
Prints bytes sent/received over OSDP to console for debugging.
LOG_HEXDUMP_DBG() is used to achieve this and can be very verbose.
config OSDP_SKIP_MARK_BYTE
bool "Skip sending the initial marking byte (0xFF)"
help
As per the OSDP specification, the first byte in the channel has
to be a MARK byte which is 0xFF. Since this is not stated in the
packet structure definition, some commercial CPs and PDs do not
handle the initial mark byte correctly. This option can be used to
completely disable sending/expecting a mark byte to work with
such non-conforming devices.
config OSDP_SC_ENABLED
bool "OSDP Secure Channel"
depends on CSPRING_ENABLED
default y
select CRYPTO
select CRYPTO_MBEDTLS_SHIM
select MBEDTLS
select MBEDTLS_CIPHER_CCM_ENABLED
help
Secure the OSDP communication channel with encryption and mutual
authentication.
if OSDP_SC_ENABLED
config OSDP_SC_RETRY_WAIT_SEC
int "Retry wait time in seconds after a Secure Channel error"
default 600
help
Time in seconds to wait after a secure channel failure, and before
retrying to establish it.
config OSDP_CRYPTO_DRV_NAME
string "Crypto driver to use with OSDP"
default "CRYPTO_MTLS"
help
OSDP Secure Channel uses AES-128 to secure communication between
CP and PD. Provide an available crypto driver name here.
endif # OSDP_SC_ENABLED
if OSDP_MODE_PD
source "subsys/mgmt/osdp/Kconfig.pd"
endif
if OSDP_MODE_CP
source "subsys/mgmt/osdp/Kconfig.cp"
endif
endif # OSDP