| # SX9500 SAR proximity sensor configuration options |
| |
| # Copyright (c) 2016 Intel Corporation |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| menuconfig SX9500 |
| bool "SX9500 I2C SAR Proximity Chip" |
| depends on I2C |
| help |
| Enable driver for SX9500 I2C-based SAR proximity sensor. |
| |
| if SX9500 |
| |
| config SX9500_DEV_NAME |
| string "SX9500 device name" |
| default "SX9500" |
| |
| config SX9500_I2C_ADDR |
| hex "SX9500 I2C slave address" |
| default 0x2B |
| help |
| Specify the I2C slave address for the SX9500. |
| |
| config SX9500_I2C_DEV_NAME |
| string "I2C master where SX9500 is connected" |
| default "I2C_0" |
| help |
| Specify the device name of the I2C master device to which SX9500 is |
| connected. |
| |
| config SX9500_PROX_CHANNEL |
| int "Proximity channel to use" |
| default 3 |
| help |
| The SX9500 offers 4 separate proximity channels. Choose which one |
| you are using. Valid numbers are 0 to 3. |
| |
| choice |
| prompt "SX9500 trigger mode" |
| default SX9500_TRIGGER_GLOBAL_THREAD |
| |
| config SX9500_TRIGGER_NONE |
| bool "No trigger" |
| |
| config SX9500_TRIGGER_GLOBAL_THREAD |
| depends on GPIO |
| select SX9500_TRIGGER |
| bool "Use global thread" |
| |
| config SX9500_TRIGGER_OWN_THREAD |
| depends on GPIO |
| select SX9500_TRIGGER |
| bool "Use own thread" |
| |
| endchoice |
| |
| config SX9500_TRIGGER |
| bool |
| |
| config SX9500_GPIO_CONTROLLER |
| string "GPIO controller for SX9500 interrupt" |
| depends on SX9500_TRIGGER |
| default "GPIO_0" |
| help |
| Specify the device name of the GPIO controller the SX9500 interrupt |
| is connected to. |
| |
| config SX9500_GPIO_PIN |
| int "GPIO pin for SX9500 interrupt" |
| depends on SX9500_TRIGGER |
| default 3 |
| |
| config SX9500_THREAD_STACK_SIZE |
| int "Sensor delayed work thread stack size" |
| depends on SX9500_TRIGGER_OWN_THREAD |
| default 1024 |
| |
| config SX9500_THREAD_PRIORITY |
| int "Thread priority" |
| depends on SX9500_TRIGGER_OWN_THREAD |
| default 10 |
| |
| endif # SX9500 |
