| Using Segger SystemView and RTT |
| ------------------------------- |
| |
| Note that when using SEGGER SystemView or RTT with this SOC, the RTT control |
| block address must be set manually within SystemView or the RTT Viewer. The |
| address provided to the tool should be the location of the ``_SEGGER_RTT`` |
| symbol, which can be found using a debugger or by examining the ``zephyr.map`` |
| file output by the linker. |
| |
| The RTT control block address must be provided manually because this SOC |
| supports ECC RAM. If the SEGGER tooling searches the ECC RAM space for the |
| control block a fault will occur, provided that ECC is enabled and the RAM |
| segment being searched has not been initialized to a known value. |
