| # Copyright (c), 2023 Nordic Semiconductor ASA |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| description: | |
| Nordic nPM1300 PMIC |
| |
| The PMIC has two buck converters and two LDOs. |
| The regulators need to be defined as child nodes, strictly following the |
| BUCK1,2 LDO1..2, node names. For |
| example: |
| |
| pmic@6b { |
| reg = <0x6b>; |
| ... |
| regulators { |
| compatible = "nordic,npm1300-regulator"; |
| |
| BUCK1 { |
| /* all properties for BUCK1 */ |
| }; |
| BUCK2 { |
| /* all properties for BUCK2 */ |
| }; |
| LDO1 { |
| /* all properties for LDO1 */ |
| }; |
| LDO2 { |
| /* all properties for LDO2 */ |
| }; |
| }; |
| }; |
| |
| compatible: "nordic,npm1300-regulator" |
| |
| include: base.yaml |
| |
| properties: |
| dvs-gpios: |
| type: phandle-array |
| description: | |
| List of SOC GPIOs connected to PMIC GPIOs. |
| Set_dvs_mode will drive these pins as follows: |
| DVS mode 1 will enable the first pin |
| DVS mode 2 will enable the second pin |
| DVS mode 3 will drive the first and second pins |
| etc. |
| The effect of the mode change is defined by the enable-gpios |
| and pwm_gpios fields for each of the regulator blocks. |
| |
| child-binding: |
| include: |
| - name: regulator.yaml |
| property-allowlist: |
| - regulator-always-on |
| - regulator-boot-on |
| - regulator-boot-off |
| - regulator-min-microvolt |
| - regulator-max-microvolt |
| - regulator-init-microvolt |
| - regulator-allowed-modes |
| - regulator-initial-mode |
| - regulator-min-microamp |
| - regulator-max-microamp |
| - startup-delay-us |
| - off-on-delay-us |
| |
| properties: |
| retention-microvolt: |
| type: int |
| description: | |
| Retention mode voltage in microvolts. |
| |
| enable-gpios: |
| type: phandle-array |
| description: | |
| Regulator enable controlled by specified regulator GPIO pin. |
| When set regulator must be enabled/disabled using set_dvs_mode. |
| |
| pwm-gpios: |
| type: phandle-array |
| description: | |
| Regulator enable controlled by specified regulator GPIO pin. |
| When set regulator must be enabled/disabled using set_dvs_mode. |
| |
| retention-gpios: |
| type: phandle-array |
| description: | |
| Retention mode controlled by specified regulator GPIO pin. |
| |
| soft-start-microamp: |
| type: int |
| enum: |
| - 10000 |
| - 20000 |
| - 35000 |
| - 50000 |
| description: | |
| Soft start current limit in microamps. |