| # Kconfig - Quark X1000 SoC configuration options |
| |
| # |
| # Copyright (c) 2014-2015 Wind River Systems, Inc. |
| # Copyright (c) 2015-2016 Intel Corporation |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| # |
| |
| if SOC_QUARK_X1000 |
| |
| config SOC |
| default quark_x1000 |
| |
| config PHYS_LOAD_ADDR |
| default 0x00100000 |
| |
| config PHYS_RAM_ADDR |
| default 0x00400000 |
| |
| config RAM_SIZE |
| default 32768 |
| |
| config ROM_SIZE |
| default 1024 if XIP |
| |
| config SYS_CLOCK_HW_CYCLES_PER_SEC |
| default 25000000 if HPET_TIMER |
| |
| config CLFLUSH_DETECT |
| def_bool y if CACHE_FLUSHING |
| |
| if SHARED_IRQ |
| |
| config SHARED_IRQ_0 |
| def_bool y |
| |
| if SHARED_IRQ_0 |
| |
| config SHARED_IRQ_0_NAME |
| default "SHARED_IRQ0" |
| config SHARED_IRQ_0_IRQ |
| default 18 |
| config SHARED_IRQ_0_PRI |
| default 2 |
| |
| endif # SHARED_IRQ_0 |
| |
| endif # SHARED_IRQ |
| |
| if PCI_LEGACY_BRIDGE |
| |
| config PCI_LEGACY_BRIDGE_BUS |
| default 0 |
| config PCI_LEGACY_BRIDGE_DEV |
| default 31 |
| config PCI_LEGACY_BRIDGE_VENDOR_ID |
| default 0x8086 |
| config PCI_LEGACY_BRIDGE_DEVICE_ID |
| default 0x095e |
| |
| endif # PCI_LEGACY_BRIDGE |
| |
| if I2C |
| |
| config I2C_CLOCK_SPEED |
| default 25 |
| |
| config I2C_DW |
| def_bool y |
| |
| if I2C_DW |
| |
| config I2C_DW_0 |
| def_bool y |
| |
| if I2C_DW_0 |
| |
| config I2C_DW_0_NAME |
| default "I2C0" |
| config I2C_DW_0_DEFAULT_CFG |
| default 0x12 |
| config I2C_DW_0_IRQ_PRI |
| default 2 |
| config I2C_DW_0_IRQ_SHARED_NAME |
| default SHARED_IRQ_0_NAME if SHARED_IRQ |
| |
| endif # I2C_DW_0 |
| |
| endif # I2C_DW |
| |
| endif # I2C |
| |
| |
| if GPIO |
| |
| config GPIO_SCH |
| def_bool y |
| |
| if GPIO_SCH |
| |
| config GPIO_SCH_0 |
| def_bool y |
| |
| config GPIO_SCH_1 |
| def_bool y |
| |
| if GPIO_SCH_0 |
| |
| config GPIO_SCH_0_DEV_NAME |
| default "GPIO_CW" |
| |
| endif # GPIO_SCH_0 |
| |
| if GPIO_SCH_1 |
| |
| config GPIO_SCH_1_DEV_NAME |
| default "GPIO_RW" |
| |
| endif # GPIO_SCH_1 |
| |
| endif # GPIO_SCH |
| |
| config GPIO_DW |
| def_bool y |
| |
| if GPIO_DW |
| |
| config GPIO_DW_0 |
| def_bool y |
| select GPIO_DW_0_IRQ_SHARED if SHARED_IRQ |
| |
| if GPIO_DW_0 |
| |
| config GPIO_DW_0_NAME |
| default "GPIO_0" |
| config GPIO_DW_0_BUS |
| default 0 |
| config GPIO_DW_0_DEV |
| default 21 |
| config GPIO_DW_0_FUNCTION |
| default 2 |
| config GPIO_DW_0_BAR |
| default 1 |
| config GPIO_DW_0_BITS |
| default 8 |
| config GPIO_DW_0_BASE_ADDR |
| default 0x90006000 |
| config GPIO_DW_0_IRQ |
| default 18 |
| config GPIO_DW_0_PRI |
| default 2 |
| config GPIO_DW_0_IRQ_SHARED_NAME |
| default SHARED_IRQ_0_NAME if SHARED_IRQ |
| |
| endif # GPIO_DW_0 |
| |
| endif # GPIO_DW |
| |
| endif # GPIO |
| |
| |
| if SPI |
| |
| config SPI_INTEL |
| def_bool y |
| |
| if SPI_INTEL |
| |
| config SPI_INTEL_CS_GPIO |
| def_bool y |
| |
| config SPI_INTEL_PORT_0 |
| def_bool y |
| |
| if SPI_INTEL_PORT_0 |
| |
| config SPI_INTEL_PORT_0_DRV_NAME |
| default "SPI0" |
| config SPI_INTEL_PORT_0_BUS |
| default 0 |
| config SPI_INTEL_PORT_0_DEV |
| default 21 |
| config SPI_INTEL_PORT_0_FUNCTION |
| default 0 |
| config SPI_INTEL_PORT_0_REGS |
| default 0x90009000 |
| config SPI_INTEL_PORT_0_IRQ |
| default 16 |
| config SPI_INTEL_PORT_0_PRI |
| default 2 |
| config SPI_INTEL_PORT_0_CS_GPIO_PORT |
| default GPIO_DW_0_NAME |
| config SPI_INTEL_PORT_0_CS_GPIO_PIN |
| default 0 |
| |
| endif # SPI_INTEL_PORT_0 |
| |
| config SPI_INTEL_PORT_1 |
| def_bool n |
| |
| if SPI_INTEL_PORT_1 |
| |
| config SPI_INTEL_PORT_1_DRV_NAME |
| default "SPI1" |
| config SPI_INTEL_PORT_1_BUS |
| default 0 |
| config SPI_INTEL_PORT_1_DEV |
| default 21 |
| config SPI_INTEL_PORT_1_FUNCTION |
| default 1 |
| config SPI_INTEL_PORT_1_REGS |
| default 0x90008000 |
| config SPI_INTEL_PORT_1_IRQ |
| default 17 |
| config SPI_INTEL_PORT_1_PRI |
| default 2 |
| config SPI_INTEL_PORT_1_CS_GPIO_PORT |
| default GPIO_DW_0_NAME |
| config SPI_INTEL_PORT_1_CS_GPIO_PIN |
| default 2 |
| |
| endif # SPI_INTEL_PORT_1 |
| |
| endif # SPI_INTEL |
| |
| endif # SPI |
| |
| if UART_NS16550 |
| |
| config UART_NS16550_PCI |
| def_bool y if PCI |
| |
| config UART_NS16550_PORT_0 |
| def_bool y |
| |
| if UART_NS16550_PORT_0 |
| |
| config UART_NS16550_PORT_0_NAME |
| default "UART_0" |
| config UART_NS16550_PORT_0_IRQ_PRI |
| default 0 |
| config UART_NS16550_PORT_0_BAUD_RATE |
| default 115200 |
| config UART_NS16550_PORT_0_OPTIONS |
| default 0 |
| config UART_NS16550_PORT_0_PCI |
| def_bool y if UART_NS16550_PCI |
| |
| endif # UART_NS16550_PORT_0 |
| |
| config UART_NS16550_PORT_1 |
| def_bool y if PCI |
| |
| if UART_NS16550_PORT_1 |
| |
| config UART_NS16550_PORT_1_NAME |
| default "UART_1" |
| config UART_NS16550_PORT_1_IRQ_PRI |
| default 3 |
| config UART_NS16550_PORT_1_BAUD_RATE |
| default 115200 |
| config UART_NS16550_PORT_1_OPTIONS |
| default 0 |
| config UART_NS16550_PORT_1_PCI |
| def_bool y if UART_NS16550_PCI |
| |
| endif # UART_NS16550_PORT_1 |
| |
| endif # UART_NS16550 |
| |
| |
| if ETH_DW |
| |
| config ETH_DW_0 |
| def_bool y |
| |
| if ETH_DW_0 |
| |
| config ETH_DW_0_BASE_ADDR |
| default 0x90002000 |
| config ETH_DW_0_IRQ |
| default 18 |
| config ETH_DW_0_IRQ_SHARED_NAME |
| default SHARED_IRQ_0_NAME if SHARED_IRQ |
| |
| endif # ETH_DW_0 |
| |
| endif # ETH_DW |
| |
| # Pin multiplexer uses PCAL9535A, needs to be initialized after it |
| config PINMUX_INIT_PRIORITY |
| default 80 if PINMUX |
| |
| if UART_CONSOLE |
| |
| config UART_CONSOLE_ON_DEV_NAME |
| default "UART_1" |
| |
| endif |
| |
| if BLUETOOTH_UART |
| |
| config BLUETOOTH_UART_ON_DEV_NAME |
| default "UART_1" |
| |
| endif |
| |
| endif # SOC_QUARK_X1000 |